10m 5V Distance Sensor Analog Output

10m 5V Distance Sensor Analog Output 

The voltage module function is to convert the distance measured by the cheap Laser Distance Sensor into a voltage output, the measuring distance range is 0.3-10M, and the output voltage range is 0-5V.
The outdoor laser distance sensor from solve a wide variety of analog applications.Some times, customers also called they need 4-20mA laser distance sensor price. 

Key parameters: Simple, fast, long, precise 

Test interface: usb/rs232/rs485

Accuracy: +-1mm
Measuring time: 0.125s-4s
Size: 45*25*12mm

Detailed parameters:

Model Number: DA93A
Measuring time: 0.125s-4s
Invisible measuring: 620nm-690nm, red
Measuring range: 0.03-10 m
Measuring accuracy: +-1 mm
Laser type: Class 2 laser
Electrical Level: TTL/CMOS
Interface options: USB, RS232, RS422
Working temperature: 0 ~ 40 Celsius
Storage temperature: -10 ~ 60 Celsius

More Detailed Pictures:

How to order the samples?

Diagram for the Laser Distance sensor:

P2: laser ranging module port instruction

TX1:  Motherboard serial port transmit pin, connect to serial port receive pin of distance module(Orange)
RX1:  Motherboard serial port receive pin, connect to serial port transmit pin of distance module(White)
EN:   Distance module power up enable pin, active high, low level off, connect to distance module PWREN(Yellow)
V3.3: 3.3V voltage output positive,connect to distance module 3.3V(Red)
DG:   3.3V voltage output negative, connect to distance module GND(Black)

How to use your module to test?
There is a simple steps for you:
1. install the Gese software and USB driver on your computer.

2. Then you can send the related command to test

Basic Commands Demonstration
"O": switch on the laser; 
"C": switch off the laser command 
"S": get module status; 
"V": get module version information; 
"D”: automatic measurement; 
"M": slow measurement; 
"F": quick measurement.

Continuous Measurement

Continuous measurement can be used on all measurement modes: auto measurement, slowmeasurement and fast measurement.  
1. Enter continuous measurement: after pulling the control pin P13.nCTRL lower, enter D or M or F, the module will start measuring, the measuring speed is according to the command you just entered. 

2. Exit continuous module: Pull the control pin P13.nCTRL higher when the module is continuous measuring, the continuous measurement mode stop immediately.

JRT is participating in the Russian International Hardware Show, welcome to our booth.
Time: November 5-8, 2019
Location: Ruby Pavilion PAV.8.1 & 8.2.
Our Booth No.: HALL8.1 D2104

Chengdu JRT Main Ranging Modules: laser distance meter module, industrial laser distance sensor, mini TOF ranging sensor.