150m UART Radar Sensor Electronic

150m UART Radar Sensor Electronic

The radar sensor is a high-Precision Laser Distance Sensor, which is using phase-based ranging principle. The process is to detect between the sensor and objects, and measuring how far away the object is. With Radar sensor electronic, a low-powered laser shoots accurate pulses at a target, and measures max up to 150m. 

Reliable laser measuring Manufacturer
➢ Features half the dead zone as previous US radar products
➢ Wide ranging up to 150m;
➢ 620nm-690nm Laser Ranging Sensor, class 2 standard;
➢ Low power consumption, Millimeter-level high accuracy;
➢ Stable performance, strong anti-light interference environment ability;
➢ Wide ranging range, up to 60m;
➢ Small size, easy installation and long life.

Features
Max length from 30 mm...150000 mm
Fast response time 0.4s-4s for high-speed 
Interface option: serial/rxtx, usb output
How is our customers use the distance to test?
Normally, our customers will order the usb cable distance module, as it can be used to test easily, via installing and inserting the USB into their computer.

Techinical parameters

Measuring time: 0.4s-4s
Accuracy: ±3 mm
Measuring Unit: mm
Applications support connect to your Arduino/Raspberry Pi etc.
Measuring Range 0.03-150m
Laser Class Class II
Laser Type 620nm-690nm, <1mW
Size 64*40*18mm
Weight About 13g
Voltage DC2.0~3.3V
Electrical Level TTL/CMOS
Frequency 3 Hz
Operating Temperature 0-40 ℃ (32-104 ℉ )
Storage Temperature -25~60 ℃ (-13~140 ℉)

Notes:

1. Under bad measure condition, like environment with strong light or the diffuse reflectance of measuring point over-high or low, the accuracy would have bigger amount of error: ±1 mm+40PPM.

2. Under strong light or bad diffuse reflectance of target, please use a reflector.
3. Voltage can be changed by power converter LDO
4. Frequency would be affected by environment.
5. Operating temperature -10 ℃~50 ℃ can be customized.
6. Analog can be customized.

Instruction for the 150m Laser Radar Sensor:

How to package your laser distanc sensor of four samples?

How to use your module to test?
There is a simple steps for you:
1. install the Gese software and USB driver on your computer.

2. Then you can send the related command to test

Communication
1.‘O’(0x4F): Turn ON laser beam, and return “,OK!”; 
2.'C'(0x43): Turn OFF laser beam, and return “, OK!”; 
3.'S'(0x53): Module status read, module returns Temperature & Battery Voltage, e.g.: “18.0’C, 2.7V”; 
4.'D'(0x44): Auto mode Distance read.

Hardware Connections 
1. Hardware Interface: 2 line USART(Rx, Tx); 
2. Baudrate: 19200bps; 
3. Data bits: 8b; 
4. Parity: none; 
5. Flow control: none.

Some test datas from our customers: customers said it's a Precision Distance Sensor.

Feedbacks: Customer to JRT for our Long Range Distance Sensor BA6A (the previous version of B87A):
Hi dear,
I can confirm 40x BA6A laser sensors have been received successfully, visually all looks good,
Thank you for your help and patience

Chengdu JRT Main Ranging Modules: Industrial Laser Distance Sensors, Laser Rangefinder Sensor , Tof LiDAR Sensors.